Mycotal FAQ

is very unlikely due to the complex nature by which Mycotal interacts with the target pest. How to handle & apply Mycotal How to store Mycotal? Mycotal [...] at a temperature between 2°C and 6°C. The expiry date of the product can be found on the packaging. How to apply Mycotal? Mycotal is applied as a foliar [...] Systems in greenhouses. How to use Mycotal How to use Mycotal with Low Volume Mist System What are the optimal conditions to apply Mycotal? • Mycotal

Manual Wireless Beehome

Switching on the transmitter signal You can use a timer to switch on the transmitter signal. Alternatively, you can connect the transmitter to the climate [...] address (see above for instructions on how to set the address/frequency) will have to be installed in the aisle. In order to prevent signal interference, the [...] Red LED on transmitter does not light up. Receiver will not turn on. Receiver will still not turn on. The receiver turns on but is not receiving a signal

Plant Pollinator interactions in high temperatures

essential to point out that exposure to maximum temperatures of more than 30° C for a couple of hours has a negligible effect on pollination. However, a full [...] hand. A humidity of 85% is fine for pollination in a semi-closed greenhouse, while a humidity of more than 80% starts to impede pollination in a conventional [...] of summer plantings. A combination of high light and low humidity forces the plant to work too hard, and as a result, the setting on the first fruit is skipped

Spidex Vital FAQ

impossible? After years of research, Koppert has managed to develop a new formulation for better control of a number of vital aspects. This results in keeping [...] formulation of Phytoseiulus persimilis. Is this a different Phytoseiulus species to the Spidex I am used to? No, it is exactly the same Phytoseiulus species [...] Why does it have a different colour than the Spidex I’m used to? During production of Spidex Vital the predatory mites don`t get to eat spider mites,

Manual Growing lights

growing lights come on and start to close 10 to 12 hours later. Switching on the growing lights before midnight, causes the flowers to close as early as [...] it takes up to 60-90 minutes for the last foraging bumblebee to return to the hive. Under low light conditions, this time increases up to 120 minutes. [...] conditions it may be better not to release the bumblebees on the specific day, but to open the hive the following day. Never keep a hive closed for longer than

General Conditions Koppert

prejudice to Koppert’s right to demand compliance with the obligations to which the penalty clause pertains and without prejudice to Koppert’s right to claim [...] Buyer refuses to meet Koppert’s request to that effect, Koppert shall furthermore have the right to immediately demand the purchase sum, or to dissolve by [...] s soon as the Buyer is in breach, the Buyer is obliged to pay to Koppert A interest on the total exigible amount at the rate of the currently applicable

Pollination checklist Growing lights

will have a negative effect on the development of the hives. 10:00 1! Bumblebees need max. 2 hours to return to their hive 15:00 Do not keep a hive closed [...] transmitter to the climate computer. Heat Do not turn the lights on before midnight Screens and filters Place the Natupol hive with the WBH on a Natupol [...] autumn. The later the lights are turned on, the more time (overlap with daylight) there is for the bumblebees to pollinate. For pollination, bumblebees